When you have you put the mouse points on a photograph, I turn into the photograph which I set gunpowder at.

	It is a cartridge for paper CAP of MGC. It is a cartridge for M73. A thing used for REV and a standard type is different in an external form, but it is the same structure.。
	It is a CV cartridge of MGC. I used paper gunpowder. There is air space more below from a set position of paper CAP. Because there was this air space (a gas swimming pool),I was able to make it big clearance between detonator and cartridges.
	It is a resin cartridge for MGC GM2. I used paper gunpowder. A fire ring plate beats an inner part of a cartridge and reaches fire.
	It is a REV cartridge using CAP of MGC. A blow of a hammer moves an inside piston and Moved || inner || is similar, and push it, and CAP appears more, and hit ディト in a cylinder, and catch fire. An existing article is the same, too.
	It is PFC of Marushin. CAP applies ignition side to the rim side and sets it. Because ignition is side fire, the whole cartridge moves. Detonator is in a mortar of a piston-shaped part、and open a hole in a CAP gunpowder base by ignition, and ignition gas comes to fall out.
	It is center fire PFC of Marushin. CAP applies ignition side to the rim side and sets it. Because ignition is center fire, a inner part moves and catches fire. Ignition gas comes to come out of a CAP base from a hole of an ignition time piston part.